Next, you need to download the app for your phone/tablet. It automatically connected to the pool control panel, downloaded the panels configuration, and was ready to go. Once the wireless kit was connected to the router, the system was powered on. Note, your wifi signal has to be strong enough to reach the antenna you just mounted at the pool control panel for this work - otherwise you'll have to try and run a hard wire from your house to the pool - I didn't have to. The two boxes connect together with a provided wire, then connect to the wifi router with a cat5 or cat6 cable, and plug into the wall for power. You then head inside the house and install two small boxes to your primary internet connection. Since I had a previous antenna, it was very easy to remove and install in the same position. You mount the provided wireless system board in the provided antenna casing, and plug into your control panel. I had to install the updated kit which took about 3 minutes. The old remote had a wireless kit installed on the pool control panel. (I found it a little missleading that the picture shows the wireless remote - it isn't part of what you are puchasing with this kit, but it isn't required either). When the wireless remote (like the one in the picture) stopped working, and I chose to move to a mobile app based solution instead. Let me start by saying I had an existing pentair remote system installed for my pool already.

Screenlogic connect not working